MIK-TRC 400 Residual chlorine meter has a built-in sensor, which has the characteristics of high measurement accuracy, fast response time and low maintenance cost.
Measure range:
Residual chlorine: (0~5) mg/L
Temperature: (0.1~40.0)℃
Load Resistance: ≤750Ω
Power supply: 220VAC
Specification
SUP-TRC 400 Residual chlorine meter
| Product | Residual chlorine meter |
| Model | MIK-TRC 400 |
| Measure range | Residual chlorine: (0~5) mg/L Temperature: (0.1~40.0)℃ |
| Display | 7 inch touch screen |
| Protective box size | Dimensions: 400mm×300mm×200mm Window size: 155mm×87mm |
| Transmit output | (4~20)mA (optional) |
| Load resistance | ≤750Ω |
| Communication | RS485, Modbus |
| Environmental humidity | ≤95% no condensate |
| Power supply | 220VAC |
| Ingress protection | IP43 |
SUP-ERC 400 Residual chlorine sensor
| Measurement content | HCLO、CLO2 |
| Measuring system | Microelectronics MEMS technology, special membrane structure |
| Measure range | (0~5）mg/L |
| Accuracy | When ≤0.1mg/L, the absolute error is ±0.01mg/L; When ≥0.1mg/L, ±5% of the measured value or ±0.02mg/L (whichever is greater) |
| Resolution | 0.01 |
| Polarization time | When using for the first time, first pass water for 2 hours in chlorinated water, and then power on for half an hour. |
| Response time | Less than 30s after polarization is completed |
| Minimum conductivity | ≥100us/cm, can not be used for ultrapure water |
| Operating temperature | (0~40)℃ (non-condensing) |
| Temperature compensation | Pt1000 with built-in integrated automatic compensation |
| Max pressure | 4bar |
| Recommended flow rate | ≥0.03m/s in flow cell |
| pH range | (5~9) pH, below 5 will damage the membrane head |
| Maximum chlorine concentration | ≥5ppm |
| Power supply | Standard 24V DC±2V; optional 12V DC±2V |
| Power consumption | 1.56W |
| Digital communication | MODBUS RS485 |
| Cable length | Standard 3 meters, others can be customized |
| Probe weight | 210g |
| Thread size | NPT 3/4 |
| Connection method | 5-pin waterproof aviation plug |
| Moisture-proof material | PVC and Viton® O-ring seals |
The residual chlorine meter has a built-in sensor, which has the characteristics of high measurement accuracy, fast response time and low maintenance cost. The residual chlorine meter outputs 4~20mA standard signal and RS485 signal, which can be connected to various regulators, and can be connected to two-position regulators, time proportional regulators, non-linear regulators and classic PID regulators according to requirements, which can be combined into various types. Residual chlorine control system.
We use cookies to collect information about how you use this site. We use this information to make the website work as well as possible and improve our services.
